Drive Axle Oil Level - Check; Mast, Carriage, Lift Chains & Attachments - Inspect, Lubricate; Steering Mechanism - Check, Lubricate - Daewoo Forkilt Operation & Maintenance Manual

Maintenance Section

Drive Axle Oil Level - Check

Park the lift truck on a level surface. Apply the
parking brake. The engine at low idle. Place the
directional control lever in NEUTRAL.
1. Remove the dip stick/filter cap. Observe the oil
level.
2. Maintain the oil level between the lower mark
and upper marks on the dip stick/filter cap.
Mast, Carriage, Lift Chains &
Attachments - Inspect, Lubricate
1. Operate the lift, tilt and attachment controls.
Listen for unusual noises. These may indicate a
need for repair.
2. Inspect for loose bolts and nuts on the carriage.
Remove any debris from the carriage and mast.
3. Inspect the forks and attachments for free
operation and damage. Have repairs made if
necessary.
4. Brush a film of oil on all links of the chain.
5. Raise and lower the carriage a few times to
allow lubricant to enter into the chain links.
Lubricate chains more frequently than normal in
applications where the lift truck is operating in an
atmosphere which could cause corrosion of
components or when lift truck must work in rapid lift
cycles.
6. Inspect the chain anchors and individual links
for wear, loose pins or cracked leaves.
Steering Mechanism - Check,
Lubricate
1. Lubricate the steer axle king pins, total of four
fittings. Two on the right side and two on the left
side.
2. Lubricate the steering link bearings, total of four
fittings. Two on the right side and two on the left
side
3. Check for any worn or loose components of the
steering mechanism. Remove any debris or
trash as
-166-
NOTICE