Daewoo Forkilt Operation & Maintenance Manual page 70

Operation Section
CAUTION
When closing the engine hood, be careful not to
pinch your hand.
Circuit Breaker
Circuit Breaker
electrical circuits. To reset the circuit
breaker, push the button in. Located in the
engine compartment.
Seat
NOTE: Seat arrangements may vary.
Basic operation will be similar.
Seat adjustment should be checked at the
beginning of each shift and when operators
change.
Lock the seat into position before operating, to
prevent an unexpected seat change.
Adjust seat to allow full brake pedal travel with
operator's back against seat back.
NOTE: The seat can only be correctly adjusted
with the operator fully seated.
-Protects the main
Fuel Selector Switch (G424 Dual
Fuel Only)
NOTE: The switch is located in the engine
compartment.
1. LPG - This position supplies electrical
power to the LP fuelock solenoid, when
the ignition switch is in the ON or the
START position.
With the LP-Gas fuel tank valve open and when
engine oil pressure is present, LP-Gas can then
flow the tank through the converter to the
carburetor.
2. OFF - This position shuts off all fuel
supply to the carburetor and is used
when changing from Gasoline to LP-Gas
or LP-Gas to Gasoline fuel.
Electrical power shuts off the gasoline fuelock valve
and the LP fuelock solenoid. Before switching to
the LPG position, allow the engine to run until all of
the gasoline in the carburetor is consumed and the
engine stops.
3. GAS - This position supplies electrical
power to gasoline fuelock solenoid. This
will allow gasoline fuel to flow from the
tank through the fuel
pump to the carburetor.
-68-
filter and fuel