Daewoo Forkilt Operation & Maintenance Manual page 14

Safety Section
Make sure the lift truck horn, lights, backup alarm (if
equipped) and all other devices are working
properly.
Check for proper
attachments. Pay particular attention to unusual
noises or erratic movement which might indicate a
problem.
Make sure service and parking brakes, steering,
and directional controls are operational.
Make sure all personnel are clear of lift truck and
travel path.
Refer to the topic "Lift Truck Operation" in the
"Operation Section" of this manual for specific
starting instructions.
Starting the Lift truck
Do not start the engine or move any of the controls
if there is a "DO NOT OPERATE" or similar warning
tag attached to the start switch or controls.
Before Operating the Lift Truck
Test brakes, steering controls, horn and other
devices for proper operation. Report any faulty
performance. Do not operate lift truck until repaired.
Learn how your lift truck operates. Know its safety
devices. Know how the attachments work. Before
moving the lift truck, look around. Start, turn and
brake smoothly.
An operator must constantly observe his lift truck
for proper operation.
operation of mast
Operating the Lift Truck
Always keep the lift truck under control.
Obey all traffic rules and warning signs.
and
Never leave the lift truck with the engine operating,
or with the parking brake disengaged.
Operate the engine only in a well ventilated area.
Lower a mast, with or without load, before turning
or traveling. Tip over could result. Watch out for
overhead obstructions.
Always observe floor load limits and overhead
clearance.
Start, turn, and brake smoothly. Slow down for
turns, grades, slippery or uneven surfaces.
Use special care when operating on grades. Do not
angle across or turn on grades. Do not use lift truck
on slippery grades. Travel with forks downgrade
when unloaded. Travel with load upgrade.
Do not overload, or handle offset, unstable, or
loosely stacked loads. Refer to load capacity plate
on the lift truck. Use extreme caution when
handling suspended, long, high or wide load.
-12-