Fuel Lines & Fittings - Check; Inspect Mixer Assembly (G424E/G430E Engine Only); Inspect Throttle Assembly (G424E/G430E Engine Only); Fuel Filter (Db33A Diesel Engine Only) - Change - Daewoo Forkilt Operation & Maintenance Manual

Maintenance Section
Fuel Lines & Fittings - Check
Visually inspect fuel lines and fittings for physical
damage. Replace as required.
1
(1) Fuel lines
(2) LP mixer
(3) Throttle Assembly
Inspect Mixer Assembly
(G424E/G430E Engine Only)
Refer to the LP mixer section of the engine service
manual for procedures.
Inspect Throttle Assembly
(G424E/G430E Engine Only)
1. Visually inspect the throttle assembly motor
housing for coking,
cover-retaining clips. Repair and/or replace as
necessary.
NOTE: Refer to the LP mixer and throttle section of
the service manual for procedures on
removing the mixer and inspecting the
throttle plate.
2
3
cracks and missing
Fuel Filter (DB33A Diesel Engine
Only) - Change
Diesel Engine
DB33A Diesel Engine
1. Remove fuel filter cartridge assembly.
2. Remove sensor
assembly.
3. Before installing a new cartridge assembly,
assemble existing sensor assembly and apply a
small amount of clean fuel to the filter cartridge
gasket.
Do not fill fuel filters with fuel before installing
them. Contaminated fuel will cause accelerated
wear to fuel system parts.
4. Install the new fuel filter cartridge assembly.
5. Turn the new fuel filter cartridge assembly until
the filter gasket is fitted against the sealing
face.
6. Turn the fuel filter cartridge assembly an
additional 2/3 of turn.
-184-
assembly from cartridge
NOTICE