Parking Brake - Test, Adjust - Daewoo Forkilt Operation & Maintenance Manual

Maintenance Section
6. Install the dip stick/filter cap.
NOTE: Tighten the dipstick plug fully not to allow
foreign parts(rain, water etc) to enter into
drive axle.

Parking Brake - Test, Adjust

Parking Brake Testing
NOTICE
OSHA requires the parking brake to hold the lift
truck, with capacity load, on a 15% grade.
Testing requires a test load equal to the
capacity of the truck and a 15% grade.
If the maximum grade in the workplace is less
than its capacity, use the Parking Brake
inspection procedure covered in 'Inspection
from Operator's Seat, Engine On' in "Every 10
Service Hours or Daily" section.
1. Pick up capacity load and drive over to a 15%
grade.
2. Drive forward up the 15% grade. Halfway up
the grade, stop the lift truck with its service
brakes.
3. Engage the parking brake and slowly release
the service brake.
4. Engage the parking brake and shift the
transmission to NEUTRAL. Slowly release the
service brakes.
5. The parking brake adjustment is proper if it
holds the lift truck on the grade. The parking
brake needs adjusting if it does not hold the lift
truck on the grade.
6. If the lift truck starts to move in reverse down
the grade with the parking brake engaged, stop
it with the service brakes, disengage the
parking brake and reverse slowly down the
grade controlling your speed with the service
brakes.
To prevent personal injury, the operator MUST
be ready to use the service brake if the parking
brake is not adjusted correctly and the lift truck
starts to move.
Parking Brake Adjusting
1. Park the lift truck on a level surface, lowered
the forks, shift the transmission to NEUTRAL
and shut OFF the engine and block the wheels
securely.
2. Chock the
unintentional movement.
-160-
WARNING
lift truck's tires to prevent