Siemens SINAMICS V20 Operating Instructions Manual page 197

Parameter Function
17
20
21
22
23
25
27
30
31
32
33
35
37
50
51
52
53
55
57
70
71
72
73
75
77
Dependency: Related parameter: P1074 (BI: Disable additional setpoint)
Caution: Changing this parameter sets (to default) all settings on item selected. These are the following parame-
ters: P1070, P1071, P1075, P1076
If P1000 = 1 or 1X, and P1032 (inhibit reverse direction of MOP) = 1, then reverse motor direction will be
inhibited.
Note: RS485 also supports MODBUS protocol as well as USS. All USS options on RS485 are also applicable to
MODBUS. To alter the setpoint using the BOP when the command source P0700 is not set to 1, you must
check that P1035 is set to r0019 bit 13 and P1036 is set to r0019 bit 14.
P1001[0...2] Fixed frequency 1 [Hz]
SINAMICS V20 Inverter
Operating Instructions, 09/2014, A5E34559884
Range Factory Can be
default changed
Analog setpoint 2 + MOP setpoint
No main setpoint + Analog setpoint
MOP setpoint + Analog setpoint
Analog setpoint + Analog setpoint
Fixed frequency + Analog setpoint
USS/MODBUS on RS485 + Analog setpoint
Analog setpoint 2 + Analog setpoint
No main setpoint + Fixed frequency
MOP setpoint + Fixed frequency
Analog setpoint + Fixed frequency
Fixed frequency + Fixed frequency
USS/MODBUS on RS485 + Fixed frequency
Analog setpoint 2 + Fixed frequency
No main setpoint + USS/MODBUS on RS485
MOP setpoint + USS/MODBUS on RS485
Analog setpoint + USS/MODBUS on RS485
Fixed frequency + USS/MODBUS on RS485
USS/MODBUS on RS485 + USS/MODBUS on RS485
Analog setpoint 2 + USS/MODBUS on RS485
No main setpoint + Analog setpoint 2
MOP setpoint + Analog setpoint 2
Analog setpoint + Analog setpoint 2
Fixed frequency + Analog setpoint 2
USS/MODBUS on RS485 + Analog setpoint 2
Analog setpoint 2 + Analog setpoint 2
-599.00 - 10.00 U, T
550.00
Parameter list
7.2 Parameter list
Scaling Data Data
set type
- DDS Float
Acc.
Level
2
197