Monthly Maintenance; Cleaning Interior Surfaces - Cornelius STARBUCKS UC100 PROGATE Operator's Manual

Monthly Maintenance

Clean and sanitize the hopper interior and auger assembly.

Cleaning Interior Surfaces

CAUTION: When pouring liquids into the hopper, do not exceed the rate of 1/2 gallon per
minute.
IMPORTANT: Perform the following procedure at least once a month.
1. Open right hand hopper cover and remove all ice from hopper.
2. Remove the agitator disk and agitator assembly.
3. Remove the tower cover. (See Figure 5.)
4. Move the retaining bail to the rear of the tower. This allows removal of the auger transition cap.
5. The auger tubes are in two halves. Slowly pull up and remove front half of auger tube, then the
back half of the auger tube.
6. Grasp the ice auger by the shaft end and slowly pull it up and out. It may be necessary to lean the
auger forward during removal to avoid hitting the ceiling.
7. Remove the front panel of the cabinet below the hopper, this provides access to the lower auger
drive area and the passage between the hopper and the auger for cleaning.
8. Using the previously prepared soap solution to clean the hopper cover, agitator disk and agitator
assembly, interior of the hopper, both halves of the ice chute, auger, auger tubes, and the lower
auger area of the auger housing. Thoroughly rinse all parts with potable water. Spray all
components with sanitizing solution and allow to air dry.
9. Reassemble the agitator assembly and disc into the hopper. Make certain that the retaining screw
is tight.
10. Reinstall the auger.
NOTE: The bottom of the auger has a depression in the shape of a D. When replacing the auger,
it will be necessary to rotate the auger after insertion in the tube to engage the motor shaft. Make
© 2008-2014, Cornelius Inc.
Ice Chute Cover
Locking Tab
Ice Chute Cover
Figure 4
UC100 ProGate Operator's Manual
- 7 - Publication Number: 621054211OPR