Breville BEM825 Instruction Book page 19

PROBLEM
Machine will
not work when
switched ON
Cannot set the
time on the
count-down timer
Mixer suddenly
switches off during
mixing
"E1" error message
is flashing on the
count-up/down
timer display
"E2" error message
is flashing on the
count-up/down
timer display
Noise is heard
when scraper beater
is mixing
EASY SOLUTION
•
Always ensure the speed control dial is in the OFF position
before start.
•
The temperature overload protection (thermo cut-off) device has not been
activated automatically, allow more time for the motor to cool down.
•
Always ensure the speed control dial is in the OFF position before trying to
set the count-down time.
•
The mixer has been stressed by overloading or stalling. The mixer will
automatically activate the overload protection and the unit will switch itself
off. If this happens, turn the speed control dial to the OFF position, and
unplug for at least 15 minutes. The overload protection device will reset,
and the mixer will be ready to use again when it powers back into standby
mode.
•
The mixer will automatically stop operating if the motor is stalled.
If this occurs, the 'E1' error message will flash on the count-up/down timer
display. This is an electronic safety feature. This is normally a result of too
much ingredients being processed at one time. Try removing some of the
ingredients from the bowl. To continue mixing, turn the speed control dial
to the OFF position and unplug the mixer from the power outlet. Then plug
the mixer into the power outlet and use as normal.
•
This may indicate that the motor has been stressed by overheating with
excessive load. The mixer is fitted with a self-resetting safety device which
safeguards against overheating of the motor with excessive loads.
If overheating occurs, the mixer will automatically activate the overheating
protection device and the motor will switch itself off. When the overheating
protection is activated, unplug the mixer from the power outlet for at least
15 minutes to allow the unit to cool. Turn the speed control dial to the OFF
position then plug the mixer into the power outlet and use as normal.
•
When ingredients are in the mixing bowl, the scraper beater may make
a slight noise as it scrapes the sides and bottom of the bowl. This is normal
and should not cause concern. Do not turn the mixer on with the scraper
beater in place if the mixing bowl is empty. This will cause the scraper
beater to make a loud noise as it scrapes the bowl.
19