Cisco ASR 9001 Hardware Installation Manual page 93

Installing Modules and Cables in the Chassis
Connect each AC power supply to a dedicated power source (branch circuit). Each AC-input power supply
Note
operates at a nominal input level of 100 to 240 VAC and requires at least a 15 A service for use in North
America and Japan, or a 10 A service for international use. For more information on AC power input
levels, see
Procedure
Step 1 Check that the power switch at the front of the chassis is set to the OFF position.
Step 2
Check that the circuit breaker assigned to the AC power source you are connecting is set to OFF.
Step 3 Connect the permanent ground connection (central office grounding system) to the NEBS grounding location
on the router chassis.
Note
Step 4 Plug the AC power cord into the receptacle at the front of the chassis (see the following figure).
Step 5
Close the cable wrap to secure the AC power cord plug to the power module receptacle.
Figure 55: Typical AC Power Connections
Step 6 Plug the other end of the AC power cord into the AC source receptacle.
Step 7
Proceed to
Power Connection Guidelines, on page
To ensure that power remains off while you are performing this procedure, turn the circuit breaker
switch in the off (0) position until you are ready to turn it on.
Powering on the Router, on page
Cisco ASR 9001 and Cisco ASR 9001-S Routers Hardware Installation Guide
Connecting Power to an AC-Powered Router
13.
83.
81