2-Port 10 Gigabit Ethernet Modular Port Adapter - Cisco ASR 9001 Hardware Installation Manual

Installing Modules and Cables in the Chassis
The following table describes the 4-Port 10 Gigabit Ethernet modular port adapter LEDs.
Table 10: 4-Port 10 Gigabit Ethernet Modular Port Adapter LEDs
LED Label
A/L
STATUS

2-Port 10 Gigabit Ethernet Modular Port Adapter

The 2-Port 10 Gigabit Ethernet modular port adapter provides two cages for XFP Ethernet optical interface
modules that operate at a rate of 10 Gbps. The two XFP modules can be 10-Gigabit Ethernet multimode or
single mode connections.
Each XFP cage on the 2-Port 10 Gigabit Ethernet modular port adapter has an adjacent Link LED visible on
the front panel. The Link LED indicates the status of the associated XFP port, as described in
on page 99
Color
Off
Green
Amber
Off
Green
Amber
section.
Cisco ASR 9001 and Cisco ASR 9001-S Routers Hardware Installation Guide
2-Port 10 Gigabit Ethernet Modular Port Adapter
State Meaning
Off Port is not enabled.
On Port is enabled and the
link is up. The MPA A/L
LED will blink green
when there is traffic
activity.
On Port is enabled and the
link is down.
Off Modular port adapter
power is off.
On Modular port adapter is
ready and operational.
On Modular port adapter
power is on and good, and
the modular port adapter
is being configured.
Status LEDs,
61