Thermador PRDS304 Care & Use Manual page 32

SECTION FIVE: USING THE OVEN
SETTING BROIL
BROIL
Only the upper electric element (PRDS Models) heats in
the BROIL mode.
Place rack in position recommended on page 29. For most foods that require
use of a non-preheated broiler, set food on two piece broil pan and place in
oven. For very fast cooking foods in which the broiler may be preheated for
no more than 2 or 3 minutes, place food and broil pan in oven after preheating
is complete.
TO SET THE OVEN TO BROIL (Dual-Fuel PRDS Models)
1. Open the door to the broil stop position.
2. Press BROIL Selector button for the oven being used.
L The OVEN ON light turns on (12" Proofing Oven only).
3. Set Thermostat to desired BROIL Temperature.
L The Cooling Blower turns on.
L BROIL (set to BROIL on control knob), medium BROIL
(set to 425˚F on control knob), or low BROIL (set to
275˚F on control knob), or any setting in between.
L The OVEN ON light turns on (large 28" Oven only).
L The HEATING light turns on.
4. Keep door open to the broil stop position throughout broil
cycle.
Your Professional Range comes with a large two-piece broil pan.
The slotted grid allows drippings to flow into the lower pan, away
from the intense heat of the broil element, minimizing spattering
and smoking.
NOTE: Successful broiling requires constant expo-
sure to infra-red heat from an electric element.
Preheating the broiler will cause the element to cycle
off sooner, reducing the effectiveness of the broil
process.
Page 30
LARGE ELECTRIC MAIN OVEN
(PRDS Models )
BROIL
OVEN ON
HEATING
12" ELECTRIC PROOFING OVEN
(Model PRDS48 only)
BROIL
OVEN ON HEATING