Thermador PRDS304 Care & Use Manual page 21

USING THE GRILL
CAUTION:
• Use extreme care when placing the grill
components into the grill compartment.
Avoid contacting the ceramic igniter which
could break preventing operation of the
grill.
• The grill must be assembled as shown. The
drip tray heat shields must be in place, and
the burner must be properly positioned
relative to the gas supply.
assembly of the grill may result in unsafe
or hazardous conditions during operation.
• Do not leave the grill unattended while in
use.
• Do not use charcoal briquettes or coals of
any kind.
Stainless
Steel Radiant
Heat
Deflector
Drip Pan
Grill
Box
Incorrect
Grill
Grate
Exploded Views and Side View of Grill
Spark igniter
Double
U-shaped
burner
Venturi
SECTION FOUR: USING THE COOKTOP
After removing all packaging materials, check to be
certain that the grill components are correctly assembled
in the grill box. The grill grates, stainless steel radiant and
the burner are assembled in the grill box from the fac-
tory. Follow the steps below to assemble the compo-
nents in the grill box.
A. Disassemble and/or remove the grill grate, stainless
steel Radiant and burner from the grill box.
B. Install the aluminum rectangular drip pan inside the
grill box as shown below.
C. Install the heat deflector in the U Section of the
burner. Make sure that the heat deflector is sloping
toward the rear of the grill box.
D. Insert the burner venturi to the orifice located at
the front center of the grill box. The holes at the
opposite burner ends must be seated on the studs at
the rear of the grill box. Then locate the heat deflec-
tor between the studs on sides of the the grill can.
E. The stainless steel radiant lies on two (2) studs on
each end of the grill can.
F. Place the grill grate, with raised food containment
rail oriented towards the grill box rear.
Burner Placement on Supports
Page 19