Configuration Procedure; Verifying The Configuration - HP FlexNetwork MSR2003 Configuration Manual

Configuration procedure

1. Configure IP addresses for the interfaces as shown in
2. Configure ARP suppression on Router A:
# Create a cross-connect group named vpna and create a cross-connect named svc in the
group.
<RouterA> system-view
[RouterA] xconnect-group vpna
[RouterA-xcg-vpna] connection svc
# Enable ARP suppression for the cross-connect svc in cross-connect group vpna.
[RouterA-xcg-vpna-svc] arp suppression enable

Verifying the configuration

1. On the base station, clear ARP entries, and ping the L3VE interface VE-L3VPN 1 of Router B.
(Details not shown.)
2. Verify that Router A has ARP suppression entries for the base station and Router B.
[RouterA-xcg-vpna-svc] display arp suppression xconnect-group
IP address
10.1.1.1
10.1.1.3
3. Enable ARP debugging on Router B to verify that Router B does not receive an ARP request
from the base station under the following conditions (details not shown):
a. Clear ARP entries on the base station.
b. Ping the L3VE interface VE-L3VPN 1 of Router B from the base station.
MAC address Xconnect-group
00e0-fc04-582c vpna
0023-89b7-0861 vpna
22
Figure 9. (Details not shown.)
Connection
svc
svc
Aging
25
25