Displaying And Maintaining Bootp Client; Bootp Client Configuration Example; Network Requirements; Configuration Procedure - HP FlexNetwork MSR2003 Configuration Manual

Step
3. Configure an interface to use
BOOTP for IP address
acquisition.

Displaying and maintaining BOOTP client

Execute display command in any view.
Task
Display BOOTP client information.

BOOTP client configuration example

Network requirements

As shown in
address from the DHCP server by using BOOTP.
To make the BOOTP client obtain an IP address from the DHCP server, perform configuration on the
DHCP server. For more information, see

Configuration procedure

The following describes the configuration on Router B, which acts as a client.
# Configure GigabitEthernet 2/0/1 to use BOOTP to obtain an IP address.
<RouterB> system-view
[RouterB] interface gigabitethernet 2/0/1
[RouterB-GigabitEthernet2/0/1] ip address bootp-alloc

Verifying the configuration

# Display the IP address assigned to the BOOTP client.
[RouterB] display bootp client
Figure 25, GigabitEthernet 2/0/1 of Router B connects to the LAN to obtain an IP
Command
ip address bootp-alloc
Command
display bootp client [ interface interface-type
interface-number ]
"DHCP server configuration
94
Remarks
By default, an interface does not
use BOOTP for IP address
acquisition.
examples."