Configuring The Port Number Of The Vam Server - HP FlexNetwork MSR2003 Configuration Manual

To configure a spoke private address range in a hub group:
Step
1. Enter system view.
2. Enter ADVPN domain view.
3. Enter hub group view.
4. Configure a spoke private
address range.
Specifying an ACL to control establishing spoke-to-spoke tunnels
The VAM server assigns the specified ACL to an online hub. The hub uses the ACL to match
received packets. If a match is found, the hub sends a redirect packet to the spoke that sent the
packet. Then, the spoke sends the VAM server the destination address of the packet, obtains the
remote spoke information, and establishes a direct tunnel to the remote spoke.
To specify an ACL to control establishing spoke-to-spoke tunnels:
Step
1. Enter system view.
2. Enter ADVPN domain view.
3. Enter hub group view.
4. Specify an ACL to control
establishing spoke-to-spoke
tunnels.

Configuring the port number of the VAM server

Step
1. Enter system view.
2. Set the port number of the
VAM server.
Command
system-view
vam server advpn-domain domain-name [ id
domain-id ]
hub-group group-name
•
Configure a spoke private IPv4 address
range:
spoke private-address { network
ip-address { mask-length | mask } | range
start-address end-address }
•
Configure a spoke private IPv6 address
range:
spoke ipv6 private-address { network
prefix prefix-length | range
start-ipv6-address end-ipv6-address }
Command
system-view
vam server advpn-domain
domain-name [ id domain-id ]
hub-group group-name
•
Specify an ACL to control
establishing IPv4 spoke-to-spoke
tunnels:
shortcut interest { acl { acl-number
| name acl-name } all }
•
Specify an ACL to control
establishing IPv6 spoke-to-spoke
tunnels:
shortcut ipv6 interest { acl
{ ipv6-acl-number | name
ipv6-acl-name } all }
Command
system-view
vam server listen-port
port-number
340
Remarks
N/A
N/A
N/A
Use either command.
By default, no spoke
private address range
is configured.
Remarks
N/A
N/A
N/A
Use either command.
By default, spokes are not
allowed to establish direct
tunnels.
Remarks
N/A
The default port number is 18000.
The port number of the VAM
server must be the same as that
configured on the VAM clients.