Advertisement
Quick Links
Advertisement
Related Manuals for ParaBody 843102
Summary of Contents for ParaBody 843102
- Page 1 843102 POWER RACK ASSEMBLY INSTRUCTIONS I II I II II Part # 6757501 Revision: 5/06/98...
- Page 2 2. Do not allow minors or children to play on or around this equipment. 3. Exercise with care to avoid injury. 4. If unsure of proper use of equipment, call your local Parabody distributor or call the Parabody customer service department at (800) 328-9714.
- Page 3 PART# DESCRIPTION 6641503 UPRIGHT 6641802 SA~T~L 6605702 BAR sUPPORT 6605802 6605902 CHIN BAR 6606002 ’ ’LOWER CONNECTOR 6606102 UPPER CON~CTOR " ’ 1/2X3"BOLr 3102910 FIGURE 1 STEP 1: ¯ Slide four 2" SQ. COVER CAPS (14) over the ends of each UPRIGHT BASE (2) as shown in F]:GURE ¯...
- Page 4 FIGURE 2 STEP 2: Insert tweJve 3 X 2"/NSERT GUH3ES (15) into the ends of each SAFETy/LML ,2. (NOTE: Make sure the INSERT GUIDES (I5) snap into the holes of the weldments.)(3) and BAR SUPPORT FIGUR~ SECURELY assemble the six SPRING PIN ASSEIVIBLI~S (12) to the each BAR SUPPOKT (4) as shown in FIGURE 2.
- Page 5 FIGURE 3 STEP 3 ¯ Insert four 2" SQ. END CAPS (13) into the ends of the UPRIGHTS (1) as shown in FIGURE ¯ Slide one BAR SUPPORT (4) and one SAFETY RAIL (3) (iN THAT ORDER) onto each UPRIGHT (1). Pull back SPRING PIN ASSEMBLIES until they pop into holes.
- Page 6 FIGURE 4 STEP 4: --’~ ¯ LOOSELY assemble each UPRIGHT (1) to the UPRIGHT BASE (2) using four 1/2 X 4" BOLTS (91, eight 1/2" WASHERS and four 1/2" LOCK NUTS (1 1). See FIGURE ¯ LOOSELY assemble the UPPER CONNECTOP, (7) using four 1/2 3"BOL TS (8), fou r 1/2 "...
- Page 7 CHIN BAR. (5) using four 1/2 X 3" BOLTS (8), four I/2" WASHERS (10), and four i/T’ LOCK (11). See FIGURE When all components are assembled, SECURELY tighten all bolt connections. THIS CONCLUDES THE ASSEMBLY OF THE 843102 PO’WER RACK.