ParaBody 425104 Assembly Instructions Manual page 13

72
91
83 3/8 X 1-1/4"
105
75
70
71
34
55
FIGURE 13
STEP 13
• SECURELY assemble the SELECTOR SHAFT (73) to the HEAD PLATE (72) using one 3/8 X 1-1/4" BOLT (83) and one 3/8"
WASHER (91).
• Insert four CAP PLUGS (55) into the top and bottom ends of the GUIDE RODS (36) as shown in FIGURE 13.
• Insert two GUIDE RODS (36) into the BASE (1) as shown on FIGURE 13. (NOTE: Lubricate GUIDE RODS (36) with silicon or teflon
spray available at most hardware stores.)
• Slide two 1-1/4 SQ. X 4-7/8" TUBES (34), two 3/4" WASHERS (71), and two WEIGHT STACK CUSHIONS (70) - IN THAT
ORDER - down over the GUIDE RODS (36).
• Using EXTREME CARE slide all fifteen WEIGHT PLATES (105) down over the GUIDE RODS (36) on to the WEIGHT STACK
CUSHIONS (70). Make sure that the keyholes of the WEIGHT PLATES (105) are all facing the right way. (NOTE: If the359101 50
LB. ADD-KIT is purchased refer to the 359101 ASSEMBLY INSTRUCTIONS now.)
• Slide the head plate assembly down over the GUIDE RODS (36) onto the weight stack.
• Attach the WEIGHT STACK LABELS (104) to the weight stack. Also insert the WEIGHT STACK PIN (75) into the first
WEIGHT PLATE (105) of the weight stack.
55
36
73
104
13
1