Advertisement
20
FIGURE 20
1/2
0
71
19
68
69
24
17
69
73
1/2
1
2
STEP 20
• Assemble two 3/4" THRUST WASHERS (68) and two PEC
CAMS (24) to the LEFT (20) & RIGHT (19) PEC ARMS, as
shown on FIGURE 20.
• Insert four 3/4" FLANGE BEARINGS (69) into the bushings
of the BEARING HOUSING (17).
•
Insert the LEFT (20) & RIGHT (19) PEC ARMS through the
3/4" FLANGE BEARINGS (69) in the BEARING HOUSING
(17) on their respective side as shown, and secure them in place
with two 3/4" STARLOCK COLLARS (73).
32
• Slide two PEC DEC ROLLER PADS (32) onto the LEFT (20)
& RIGHT (19) PEC ARMS until the ROLLER PAD (32) is
flush with the bottom of the pec arms.
•
(NOTE: If a lubricant is required coat the inside of the
ROLLER PAD (32) with rubbing alcohol or water. Also,
rotating the pad while pushing up will help ease assembly.)
• Securely assemble two 3/8" SPRING PIN ASSEMBLIES (71)
to the spring pin barrels of the PEC ARMS (19 & 20).
1/2
1/2
3
15
1/2
1/2
4
5
6
Advertisement
