Sfp Optic Ethernet Ports - Siemens RUGGEDCOM RS900GP Installation Manual

RUGGEDCOM RS900GP
Installation Guide
1
Figure 16: SC Connector
1. Tx Connector 2. Rx Connector
Figure 18: ST Connector
1. Tx Connector 2. Rx Connector
For further specifications, refer to
Section 3.4

SFP Optic Ethernet Ports

SFP (Small Form-Factor Pluggable) optic Ethernet ports are available with LC (Lucent Connector) connectors.
Make sure the Transmit (Tx) and Receive (Rx) connections of each port are properly connected and matched to
establish a proper link.
Figure 19: LC Connector
1. Tx Connector 2. Rx Connector
Specifications
For specifications on the available SFP optic Ethernet ports, refer to
Specifications".
Installation/Removal
The following sections describe how to install and remove SFP optical ports:
NOTE
SFP optical ports can be safely inserted and removed while the chassis is powered and operating.
• Section 3.4.1, "Installing an SFP Optical Port"
SFP Optic Ethernet Ports
2
1
Section 4.5, "Fiber Optic Ethernet Port
1
1
Figure 17: LC Connector
1. Tx Connector 2. Rx Connector
2
Specifications".
2
Section 4.6, "SFP Optic Ethernet Port
Chapter 3
Communication Ports
2
19