Testing The System - Panasonic K10059 User Manual

SecurityPhone.book 39 ページ ２００４年７月２１日 水曜日 午後６時５８分

Testing the System

You can check the system for proper operation. Before testing the system, you
must disarm the security mode and close all protected windows, doors, etc.
Refer to "Testing the System (To Be Conducted Weekly)" on pages 39 to 40 in the
3000EN Security Systems User's Guide.
Make sure all perimeter doors and windows are closed and
displayed.
Base Unit
1 Press [ADT].
Scroll to "TEST" by pressing [d] or [B], then
2
press [g].
3 Enter your security code.
• If you entered the wrong security code, the phone
will go back to the previous display. Try again from
step 2.
Press [0].
4
• "1=Dial" is intended for the installer.
• To remind you that the system is in the test mode,
a beep sounds at regular intervals.
• When the door or window is closed, the display
clears.
5 Open each protected door or window, listen to
the chime and confirm the zone number/zone
description on the display.
To exit the Test mode, press [g] while
6
" " is displayed, then enter your
=Abort Test
g
security code.
7 Press [STOP] to go to the standby mode.
Handset
: Press the soft key (
the cordless handset. Press [OFF] to go to the standby mode.
g
ENTER CODE
Example
1=Dial, 0=Walk
Test In Progress
ENTER CODE
), and follow steps 2 to 6 above, using
ADT
is
READY
TEST
----
=Abort Test
g
----
39