Quick Bypass; Quick Bypass - Panasonic K10059 User Manual

SecurityPhone.book 16 ページ ２００４年７月２１日 水曜日 午後６時５８分
Bypassing Protection Zones

Quick Bypass

If the Quick Bypass is programmed by the security system installer, you can set all
faulted (open) zones unprotected at once. Confirm with your installer if the Quick
Bypass is active for your system.
When Quick Bypass is used, all faulted (open) zones are unprotected, the alarm
does not sound, and an alarm signal is not sent to the Customer Monitoring Center.
Refer to "Quick Bypass" on page 21 in the 3000EN Security Systems User's Guide.
Make sure all perimeter doors and windows are closed and
displayed.
Base Unit
Press [ADT].
1
Scroll to "BYPASS" by pressing [d] or [B], then
2
press [g].
Scroll to "QUICK BYPASS" by pressing [d] or
3
[B], then press [g].
4 Enter your security code.
• If you entered the wrong security code, the phone
will go back to the previous display. Try again from
step 3.
• In a few seconds, all faulted (open) zones are
displayed and automatically bypassed.
• The "Bypass" message is displayed momentarily.
Press [STOP] to go to the standby mode.
5
Handset
: Press the soft key (
the cordless handset. Press [OFF] to go to the standby mode.
16
g
g
ENTER CODE
), and follow steps 2 to 4 above, using
ADT
is
READY
BYPASS

QUICK BYPASS

----