Samsung SCX-82x0 series Service Manual page 340

● Error code : ● E
d
U1-2131
U1-2134
● Symptom / Cause:
Fuser temperature is lower than normal-operational st p
• U1–2131 : The center of the roller is not heated.
• U1–2134 : The end of the roller is not heated.
● Troubleshooting method:
1. Turn the machine off then on.
2 If th 2. If the problem persists, check the following. bl
a. Check the voltage of Fuser unit.
b. Check the coil of Heat Lamp is broken or disconne
(Refer to 3.5.2 Halogen lamp)
c, Check if Heat Lamp is connected correctly.
d. Check the connectors on Drawer connector is fully
e. Check whether Thermostat is disconnected.
d
e
Service Manual
● Error message : ● E
Fuser Failure: #U1-2
Fuser Failure: #U1-2
p
i t h k th f ll i
7. Troubles shooting
:
2131. Turn off then on.
2134. Turn off then on.
tate. (ready, printing) ( y, p
ected.
y inserted.
7-U U-4
g)
SAMSUNG ELECTRONICS