Samsung SCX-82x0 series Service Manual page 323

● Code : ● C d
M3-2230
● Symptom / Cause : ● Symptom / Cause :
Too much paper in output bin tray (paper out put secti
- The bin full sensor actuator or sensor is defective.
● Troubleshooting method :
1. Remove the exit unit from the set. And replace the f
2. Enter the diagnostic mode, and execute the face do
When lifting the bin full actuator, if without paper is When lifting the bin full actuator if "without paper" is
reconnect the connector.
3. If the photo interrupter is broken away from the exit
interrupter.
4. Check if the photo interrupter connector, junction co
If the connector is unplugged, remove exit unit and r
5. Check if the regi connector on the engine controller
Reconnect it.
6. Replace the main board(JC92-02587A(for 8240) / JC
Service Manual
7. Troubles shooting
● Error message : ● E
Output tray is full. Re emove printed media.
ion)
face down antistatic brush.
wn bin full sensor test.
s displayed replace the photo interrupter or s displayed, replace the photo interrupter or
unit, remove the exit unit and reassemble the photo
onnector are connected properly.
reconnect the connector.
is connected properly.
C92-02587B(for 8230))
7-M -12
SAMSUNG ELECTRONICS