Samsung SCX-82x0 series Service Manual page 337

● Error code :
U1-2114
U1-2119
● Symptom / Cause:
Fuser is not heated.
• U1–2114 : The center of the roller is not heated.
• U1–2119 : The end of the roller is not heated.
● Troubleshooting method:
1. Turn the machine off then on.
2. If the problem persists, check the following.
a. Check the voltage of Fuser unit.
b. Check the coil of Heat Lamp is broken or disconne
(Refer to 3.5.2 Halogen lamp)
c. Check if Heat Lamp is connected correctly.
d. Check the connectors on Drawer connector is fully
e. Check whether Thermostat is disconnected.
d
e
Service Manual
7. Troubles shooting
● Error message :
:
Fuser Failure: #U1-2 2114. Turn off then on.
Fuser Failure: #U1-2 2119. Turn off then on.
ected.
y inserted.
7-U U-1
SAMSUNG ELECTRONICS