Samsung SCX-82x0 series Service Manual page 308

● Code : ● C d
H1-1317
H1-1318
● Symptom / Cause : ● S
t / C
Paper transport jam (paper Input section)
- The paper from the tray3 has not reached the tray3 fe
feed sensor.
- When you open and close the take away (DCF, HCF
sensor.
● Troubleshooting method :
1. Open the side & take away door. Remove the jamm
Close the Side door. After warm up, if same jam occ Close the Side door After warm up if same jam occ
2. Open the side & take away. Remove the jammed pa
and tray2 feed roller. If there is any defective part in th
3. If the white idle roller of the take away door breaks a
roller.
4. Check if the wall connector of tray3 pick up
connector.
5. Enter the diagnostic mode, and check the feed sens
If the paper is at sensor and "Without paper" messag
6. Check if the connector of the tray3 pick up unit on th
it.
7. Replace the DCF board (JC81-08324A) or HCF boa
Service Manual
7. Troubles shooting
● Error message : ● E
Paper jam in tray 3
eed sensor within normal time after passing the tray4
) door, the paper has jammed at the tray3 feed
med paper.
curs check the following curs, check the following.
aper between the feed roller of the tray3 pick up unit
is area, replace it.
away, release the inner cover and reassemble the idle
unit(JC8 81-07923A) is connected properly. Reconnect the
sor(0604-001393) test of the tray3 pick up unit.
ge is displayed, replace the sensor.
he pick up drive unit is connected properly. Reconnect
ard(JC81-07292A)
7-H H-3
SAMSUNG ELECTRONICS