Yamaha RX-V461 Owner's Manual page 37

Selecting the night listening mode
The night listening modes are designed to improve
listenability at lower volumes or at night.
Press D AMP and then press L NIGHT
1
repeatedly to select "NIGHT:CINEMA" or
"NIGHT:MUSIC".
Choices: NIGHT:CINEMA, NIGHT:MUSIC, OFF
• Select "NIGHT:CINEMA" to reduce the dynamic
range of film soundtracks and make dialog easier to
hear at lower volumes.
• Select "NIGHT:MUSIC" to preserve ease-of-
listening for all sounds.
• Select "OFF" if you do not want to use this feature.
y
When a night listening mode is selected, the NIGHT
indicator lights up in the front panel display.
2
Press G l / h to adjust the effect level while
"NIGHT:CINEMA" or "NIGHT:MUSIC" is
displayed in the front panel display.
Choices: MIN, MID, MAX
• Select "MIN" for minimum compression.
• Select "MID" for standard compression.
• Select "MAX" for maximum compression.
y
"NIGHT:CINEMA" and "NIGHT:MUSIC" adjustments are
stored independently.
Notes
• You cannot use the night listening modes in the following cases:
– when the DIRECT STEREO mode (see page 34) is selected.
– when the component connected to the MULTI CH INPUT
jacks is selected as the input source.
– when headphones are connected to the PHONES jack.
– when the sound field program is selected while you enjoy
music contents in a USB memory device etc.
• The night listening modes may vary in effectiveness depending
on the input source and surround sound settings you use.
Displaying signal information
You can display the format, sampling frequency, channel,
bit rate and flag data of the current input signal.
Press D AMP and then press Q MENU on
1
the remote control.
The top "SET MENU" display appears in the OSD.
SET MENU
TOP MENU
. ;AUTO SETUP
;MANUAL SETUP
.A;SIGNAL INFO
[ ]/[ ]:Up/Down
[ENTER]:Enter
2
Press G n repeatedly to select "SIGNAL
INFO" and then press G ENTER.
The following information about the input source
appears in the OSD.
;SIGNAL INFO
. FORMAT
SAMPLING
CHANNEL
BITRATE
FLAG
[RETURN]:Exit
Display
FORMAT
Signal format.
The number of samples per second taken
SAMPLING
from a continuous signal to make a
discrete signal.
The number of source channels in the
CHANNEL
input signal (front/surround/LFE).
The number of bits passing a given point
BITRATE
per second.
Flag data encoded in DTS, Dolby Digital,
FLAG
or PCM signals that cue this unit to
automatically switch decoders.
y
The information indicated by the cursor is also displayed in
the front panel display.
Press Q MENU again to exit from "SET
3
MENU".
Playback
DolbyD
48kHz
3/2/0.1
384kbps
None
Description
35
En