Connecting The Power Cable - Yamaha RX-V563 Owner's Manual

Connections
Connecting the wire of the AM loop antenna
Open the lever
y
The wire of the AM loop antenna does not have any polarity
and you can connect either end of the wire to AM or GND
terminal.
Assembling the supplied AM loop antenna
Note
The types of the supplied AM loop antenna is different
depending on the models.
22
En
Insert
Close the lever

Connecting the power cable

Once all connections are complete, plug the power cable
into the AC wall outlet.
AC OUTLETS AC OUTLETS
SWITCHED SWITCHED
■ AC OUTLET(S) (SWITCHED)
Australia model...................................................... 1 outlet
Korea model............................................................... None
Other models......................................................... 2 outlets
Use these outlet(s) to supply power to any connected
components. Connect the power cable of your other
components to these outlet(s). Power to these outlet(s) is
supplied when this unit is turned on. However, power to
these outlet(s) is cut off when this unit is set to the standby
mode. For information on the maximum power or the total
power consumption of the components that can be
connected to these outlet(s), see "Specifications" on
page 91.
Power cable