Table of Contents
Advertisement
Step 1d. Digital Satellite Receiver, Satellite dish, Cable box and terrestrial antenna
Follow this diagram if you have Satellite service, cable box and terrestrial antenna.
Cable or terrestrial antenna signal is passed through when you press TV/SAT button
to toggle or when the Digital Satellite Receiver is turned off.
SATELLITE
IN
DIGITAL SATELLITE RECEIVER, SATELLITE DISH,
Procedure
•
•
•
•
•
•
Note:
CABLE BOX
ANT IN
Digital Satellite Receiver
NTSC OUTPUT
R-AUDIO-L
VIDEO
VHF (SAT) /UHF
CABLE BOX AND TERRESTRIAL ANTENNA
Connect the antenna cable to one of the inputs (A or B) of the A/B switch.
If using a cable box, connect the cable wire from the wall jack to the cable box ANT
(antenna) IN jack using a standard RF cable with coaxial connector and connect the cable
box ANT (antenna) OUT jack to the other input (A or B) of the A/B switch.
If not using a cable box, connect the cable wire from the wall jack to the second input of the
A/B switch using an RF cable (not shown).
Connect the OUT signal of the A/B switch to the ANT IN jack of the Digital Satellite
Receiver.
Connect the VHF (SAT) /UHF OUT jack to the Conventional TV or Monitor by using a RF
cable.
Connect the NTSC OUTPUTS of the Digital Satellite Receiver to the A/V inputs of the
television or monitor.
If viewing video using RF Input, select either CH 3 or CH 4 in TV Output section in the
Setup menu. Tune your television to the same channel (either CH 3 or CH 4).
NOTE: A/V CABLES AND MODEM
ANT OUT
CABLE INCLUDED.
UHF/VHF
IN
AC IN
TEL LINE
OUT
G
ETTING
A/B SWITCH
TV
R-AUDIO-L
ANT IN
S
TARTED
VIDEO
19
Advertisement
Table of Contents
