How To Confirm Tests Were Successful; If A Transmission Test Ends In Failure - T&D RTR-500MBS-A Getting Started Manual

How to Confirm Tests were Successful:

For the Transmission of Current Readings, Warning Reports,
and Recorded Data Tests
When the destination is T&D WebStorage Service:
Check that a "Successful" message was displayed.
When the destination is an E-mail address:
See if the test mail has been received by the specified recipient at the set
e-mail address.
When the destination is an FTP server
(other than T&D WebStorage Service):
Check that the test data has arrived at the specified FTP Server.
For the GPS Operation Test
See if the window with the location info (latitude/longitude) has been
displayed.
* To carry out the GPS operation test, it is necessary that the GPS antenna is
properly connected to the Base Unit and then placed where it can properly
receive a signal from a GPS satellite, such as outside, or inside by the window
with an unobstructed view of the sky for optimal GPS performance.
* It takes a few minutes to obtain the location data.
For the External Contact Output Test
See if the warning device connected to the external contact output operated
properly.

If a Transmission Test Ends in Failure:

• Open [Base Unit Settings], and make sure the Mobile Data Communication info
has been entered correctly.
• Open [FTP Settings], and make sure the information about
T&D WebStorage Service has been entered correctly.
After checking above and making any necessary changes, if the
transmission test still fails, click [If you have trouble, see "The transmission
test ends in failure".] in the [Transmission Test] menu.
Communication Tests via PC
See the Operation Guide for details about test procedures and results.
[Other Useful Functions] - [Checking Signal Strength (PC)]
[Sending Current Readings] - [Making Transmission Tests]
[Troubleshooting] - [Q&A about Settings]
21