MODEL 5600SE Downflow
Control Start-up Procedures
Whenever the valve is in Service the current time of day can be set, the control programmed, or an extra regeneration
initiated at any time.
1.
Set Time Of Day
Push either the Up or Down Set Button once to adjust Time Of Day Display by one digit.
Push and hold either Up or Down Set Button to adjust Time Of Day Display by several digits.
2.
Enter Control Programming Mode
1. Push and hold for 5 seconds both the Up and down Set Buttons to enter Programming Mode.
2. Push the Extra Cycle Button once per display until all have been viewed and this mode is exited and normal
operation is resumed.
Page 4
Printed in U.S.A.