Customers Operating Information - Rinnai GRANADA MkII Operating Information And Installation Instructions

CUSTOMERS OPERATING INFORMATION
For trouble free operation, please read the following information carefully.
For your convenience, the controls on your heater are situated under the cover on the top right
hand side of the heater.
All necessary adjustments to the operation of your heater can be made with these controls.
CONNECT GAS AND PLUG INTO POWER POINT
Room must be ventilated
when this heater is in use.
Press the front control button firmly, this operates the
built in safety device and starts the electronic spark,
the centre burner will ignite. Check that the burner
has lit, continue to hold the button down for about
15 seconds. The spark will continue whilst the button
is held down.
Push front button
CONTROL BOX
GRANADA
GALAXI E
GRADUATE
3URNE
TITAN
Graduate
Galaxie
Granada
Titan
The Titan high burner control button may be in either position for ignition.
Note
If the burner does not remain alight, push the button again and release it, this will return it
to the "OFF' position. Wait 30 seconds, then repeat the ignition procedure.
(The ignition button must be in the "OFF" position before attempting re-ignition).
The burner should glow evenly after a few
minutes of operation. If there is a large
difference in the glow, or there is an unusual
amount of flame coming from the top of the
burner, contact your agent or Rinnai.
Graduate burners shown here.
-8-