Installation Instructions - Rinnai GRANADA MkII Operating Information And Installation Instructions

1 INSTALLATION INSTiWCTlONS
I
Specification: See back cover of this instruction booklet.
n UNPACKING
Undo straps, lift carton off heater.
Never lift the heater out of the carton by top louvres. Check for damage, if heater is damaged
contact supplier or Rinnai for advice.
W BEFORE USING THE HEATER
Check heater supplied is correct for gas type in your area.
Refer to local gas authority for confirmation of gas type if in doubt.
Gas type is indicated on the data plate.
1 INSTALLATION
Ventilation must comply with local regulations.
Do
not install in a room smaller than that shown
below.
Minimum room size (ma)
All States except WA Western Australia
Titan 75 37.5
Graduate 90 45
Galaxie
105
52.5
Granada
125
62.5
H x D x W must equal or exceed
minimum room size shown opposite.
150 mm
This heater must not be installed where
curtains or other combustible materials could
come into contact with it. In some cases
curtains may need restraining.
Other clearances are shown in the diagram.
This heater is not designed to be built into
bookcases or shelves.
150 mm
c=
150 mm
3
1000 mm
An EARTHED power point, and bayonet gas
connection must be close enough to where
the heater will be used to avoid stretching
the connection.
yL+~T
AFTER INSTALLATION CHECKS HAVE BEEN COMPLETED
Connect gas and power Q Follow ignition instructions
-7-