Extension Functions; Wj-Fs616 Video Multiplexer Control - Panasonic WJ-NT104 Operating Instructions Manual

EXTENSION FUNCTIONS

WJ-FS616 Video Multiplexer Control

Connection
(1) Connect MULTISCREEN OUT on the rear of the WJ-FS616 to VIDEO IN 1 on the rear of the WJ-NT104.
(2) Connect the RS-232C ports of both units with a RS-232C cable.
• Fixed Input Selection Mode
In this mode, only images from the MULTISCREEN OUT connector of the Video Multiplexer are available.
Setup
(1) On the ADMINISTRATOR SETUP PAGE, click the [SERIAL PORT] button to open the SERIAL PORT SETUP window.
For TYPE, select "WJ-FS616. Set the same communication parameters as for the WJ-FS616.
(2) On the ADMINISTRATOR SETUP PAGE, click the [MODE SETUP] button to open the MODE SETUP window.
(3) For VIDEO INPUT SELECTION MODE under OPERATION MODE SELECT, mark FIXED INPUT SELECTION MODE.
Control Operation
On the Location bar, type http://192.168.0.10/fsindex.html to open the WJ-FS616 OPERATION VIEW window.
q
w
e
59
DB25
2 ......................... 2
3 ......................... 3
6 ......................... 4
7 ......................... 5
20 ....................... 6
5 ......................... 7
4 ......................... 8
WJ-FS616
(MULTISCREEN OUT)
MULTI MULTISCREEN CAMERA/PRESET POSITION
ALARM SCREEN SELECT PUSH OPEN
LOCK
1 2 3 4
POWER RESET SPOT SEQUENCE 5 6 7 8
9 10 11 12
ON VCR
CAM
OFF
13 14 15 16
r o y
RS-232C
DB9
WJ-NT104 (VIDEO IN1)
16
OPERATE
Network Interface Unit WJ-NT104
!0 u t !1 i
1
PC
1
PC
1
LINK RCV XMT
PC
1
PC
!3
!2