Panasonic WJ-NT104 Operating Instructions Manual page 24

2. Windows98 Setup
If the Dial-Up Networking icon is not in My Computer, it is not installed. You can use the following procedure to install it.
(1) Click the Start button, point to Settings, and then click Control Panel.
(2) Double-click Add/Remove Programs.
(3) Click the Windows Setup tab, click Communications, and then click the [Details] button.
(4) Click the Dial-Up Networking check box, and then click the [OK] button.
Click OK again, and follow the instructions on your screen.
q Click the icon on the taskbar to display the Dial-Up Server dialog box.
w If more than one modem is connected, click the tab at the top of the box and select a modem to use.
e Check Allow caller access.
r Click the [Change Password...] button.
The Dial-Up Networking Password dialog box is displayed.
t Enter a password, and then click the [OK] button
Type the same password as used to set up the connection and modem/TA.
y Click the [Server Types...] button to display the Server Types dialog box.
u For Types of Dial-Up Servers, select PPP:Internet, Windows NT Server, Windows98.
i In the Advanced options field, remove checks from Enable software compression and Require encrypted password.
o Click the [OK] button.
The screen returns to the Dial-Up Server dialog box. Click the [OK] button.
24