Panasonic WJ-NT104 Operating Instructions Manual page 35

u IRIS
The connected combination camera (option) can be
controlled to close or open the iris by clicking the
[OPEN] or [CLOSE] button under IRIS. Clicking the
[OPEN] or [CLOSE] button will open or close the cam-
era iris for a specified time, after which the operation is
released automatically.
Clicking the [RESET] button on the screen will reset
the iris of the displayed camera to the factory default
setting. Iris control cannot be retained by keeping the
[OPEN] or [CLOSE] button depressed. You need to
click the [OPEN] or [CLOSE] button again.
Multi Input Selection Mode
q
w
e
r
q INPUT SELECT
These buttons are used to switch images from up to
four cameras.
A change of channel by one user affects only that ter-
minal, but not the channels monitored by other users.
w PRESET SELECT
To move the combination camera (option) connected to
the WJ-NT104 to any of 8 preset position numbers.
To register preset positions refer to the CAMERA
MENU SETUP on page 53.
e QUAD SCREEN MODE
Clicking this button will display images of up to four
cameras in quad pattern on a single monitor screen.
r ALARM LIST
Camera video input before and after alarm input can
be temporarily stored in the internal memory of the WJ-
NT104.
For alarm display see ALARM LIST on page 37.
35
i AUTOPAN
The auto pan status of the connected combination
camera (option) can be changed by clicking the [ON]
or [OFF] button under AUTOPAN.
Note: When LOCAL is selected in the camera setup,
AUTOPAN automatically stops after 1 minute.
When REMOTE is selected in the camera setup,
AUTOPAN will not be released automatically.
o PRESET
To move the connected combination camera (option) to
any of 64 preset positions. Select a preset position
number then press the [SET] button to move the cam-
era to the position.
t Live image display
Images of the selected camera are displayed on the
default page as semi-animated pictures.
y Pan/Tilt
Clicking anywhere on the live image moves the con-
nected combination camera (option) up and down, or
to the right and left.
decreases as the point clicked moves closer to the
image center. Clicking the image center will not move
the camera. Zooming does not change the camera
pan/tilt angle. Click the image repeatedly to move the
camera to the desired position. You cannot pan or tilt
the camera continuously by dragging on the live
image.
t
y
u
i
o
!0
!1
The camera pan/tilt angle