Yamaha RX-V3900 Owner's Manual page 131

Problem
An audio source The audio source component is not
cannot be recorded by connected to the DIGITAL INPUT jacks.
the digital recording
Some components cannot records Dolby
component connected
Digital or DTS sources.
to the DIGITAL
OUTPUT jacks.
You are trying to record an audio source
input at the DOCK terminal by the digital
recording component connected to the
DIGITAL OUTPUT jacks.
(U.S.A. model only)
HD Radio signals are not output at the
DIGITAL OUTPUT jacks
An audio source The audio source component is not
cannot be recorded by connected to the analog AUDIO IN jacks.
the analog recording
XM Satellite Radio and SIRIUS Satellite
component connected
Radio signals are not output at the analog
to the analog AUDIO
AUDIO OUT (DVR, VCR or MD/CD-R)
OUT (DVR, VCR or MD/
jacks.
CD-R) jacks.
Recorded materials The settings made on this unit (such as
sound differently. tonal quality, volume level and sound field
programs) do not affect recorded material.
The sound field "Memory Guard" is set to "On".
parameters and some
other settings of this
unit cannot be
changed.
This unit does not The internal microcomputer has been
operate properly. frozen by an external electric shock (such
as lightning or excessive static electricity)
or by a power supply with low voltage.
"CHECK SP WIRES" Speaker cables are short-circuited.
appears in the front
panel display.
There is noise
This unit is too close to the digital or high-
interference from frequency equipment.
digital or radio
frequency equipment.
The picture is The video source uses scrambled or
disturbed.
encoded signals to prevent dubbing.
This unit suddenly The internal temperature becomes too
enters the standby
high and the overheat protection circuitry
mode. has been activated.
Cause
Connect the audio source component to the DIGITAL
INPUT jacks.
Connect the recording component to the analog
AUDIO OUT (DVR, VCR or MD/CD-R) jacks.
Connect the recording component to the analog
AUDIO OUT (DVR, VCR or MD/CD-R) jacks.
Connect the audio source component to the AUDIO
IN jacks.
Set "Memory Guard" to "Off".
Disconnect the power cable from the AC wall outlet
and then plug it in again after about 30 seconds.
Make sure all speaker cables are connected correctly.
Move this unit further away from such equipment.
Wait about 1 hour for this unit to cool down and then
turn it back on.
Troubleshooting
Remedy
See
page
20
20
20
20
97
—
12
—
—
127
En