To take up media in LOOSE winding mode
To prevent media winding deviation, set the paper tube flange to the scroller. Note that the rubber spacers are
required depending on the paper tube length as explained below.
Paper tube flange (2 pcs)
Paper tube, longer than the media width
Rubber
spacer A
Paper tube flange
Paper tube, at length conforming with the media width
Rubber
spacer A
Paper tube flange
Rubber spacer B s application
When the paper tube's inner
diameter is not sufficiently longer
than the flange spacer's diameter, the
flange spacer cannot be pushed all
the way in the paper tube, and the
gap may be found between the
rubber spacer A and the paper tube
edge. In such a case, to clear the gap
set the rubber spacer B between the
rubber spacer A and the paper tube.
Rubber spacer A
58
IP-7900-26/IP-7700-26 Basic Operation Guide
Rubber spacer A
(1 pc)
Rubber
Rubber
spacer B
spacer C
Paper tube
Rubber
Rubber
spacer B
spacer C
Set the paper tube flange
to rubber spacer A.
Rubber spacer B
Rubber spacer B
Rubber spacer C
(1 pc)
Media
メディア
Attach the paper tube flange to the
paper tube.
Rubber spacer A
Paper tube
Media
Paper tube
Set the paper tube flange
to rubber spacer C.
(1 pc)
Rubber spacer C