Oki IP-7900-26 Operation Manual page 62

CAUTION
- Apply the paper tube with the same length as the media width.
1
Scroller flange
Handle
Scroller flange
Knob screw
2
IP-7900
IP-7700
3
62
IP-7900-26/IP-7700-26 Basic Operation Guide
Paper tube
Scroller shaft
Flange shaft fixture
Take-up direction switch
OFF
Install the scroller shaft and scroller flange onto
the paper tube.
(1) Pass the scroller shaft through the roll spacer with
fixtures at its both sides, scroller flange, and flange
shaft fixture.
(2) Pass the scroller shaft through the paper tube.
(3) Insert the scroller flanges into the paper tube's both
edges as far as they go.
(4) By rotating the handle fix the scroller flange.
CAUTION
- If you keep loosening the scroller flange handle, it
will block at a certain level.
Unscrewing the handle beyond that limit may
damage the scroller flange. Pay attention when
loosening the handle.
(5) Cover the scroller flange's convex part with the
flange shaft fixture, and push the flange shaft fixture
as far as it goes.
(6) Turn the knob screw to fix the scroller shaft.
Set the take-up direction switch to OFF.
CAUTION
- If the Printer processing proceeds to the next step
with the take-up direction switch set to ON, your
hand may be caught as the scroller flange is not
secured.
Install the paper tube into the Printer's front side
(take-up side).
CAUTION
- Be careful not to trap your hand or fingers between
the Printer and scroller shaft.