Table of Contents
Advertisement
Options
Exhaust attachment (IP7-013)
An optional unit to attach an exhaust duct to the Printer
The recommended flow of air is as follows.
H-104s: 1.2 to 1.8 cmm (air velocity 3.0 to 4.5 m/s)
H-74s: 1.2 to 1.3 cmm (air velocity 2.5 to 3.2 m/s)
* cmm = cubic meter per minute
Mesh printing kit 104 (IP7-011)
Mesh printing kit 74 (IP7-017)
Used to print unbacked mesh banner.
Footswitch (IP7-014)
The footswitch allows you to operate the take-up reel unit by foot. This
improves work efficiency.
(Footswitch connected to the take-up reel unit)
− Use the take-up direction switch on the take-up reel unit of the printer to set inner take-up or outer take-
up.
− The black switch of the footswitch has the same function as the take-up reel switch (black) of the take-up
reel unit. Press the black footswitch to take up media to the take-up scroller.
− The white switch of the footswitch has the same function as the media feed switch (white) of the take-
up reel unit. Press the white footswitch to feed media from the take-up scroller.
(Remark)
− Attaching footswitches do not increase power consumption.
CAUTION
− Do not use footswitches in a humid place or a place exposed to water to prevent a failure.
− Do not connect or disconnect the footswitch with wet hand to prevent a failure.
− When ink adheres to the footswitch, remove it immediately. If the footswitch is left with ink for a while, the switch surface may
be damaged.
− Hold the connector of the footswitch cable when connecting or disconnecting the footswitch. Pulling the cord of the cable may
result in disconnection or poor contact of the connector.
− Be sure to connect the ground lines. Otherwise, a malfunction or failure due to noise may be caused.
− Do not press the footswitch strongly. This may cause a failure of the switch part.
− Do not put anything on the footswitch cable. Doing so may result in disconnection or other failure.
131
Advertisement
Table of Contents
