Dell NX430 Owner's Manual page 92

Figure 26. Removing and installing the iDRAC port card
1. screw
3. iDRAC port card board
5. tabs on the iDRAC port
7. iDRAC port card connector
Next steps
1. Install the iDRAC port card.
2. Install the cooling shroud.
3. If disconnected, reconnect the network cable.
4. Follow the procedure listed in the After working inside your system section.
Related Links
System board connectors
Safety instructions
Before working inside your system
After working inside your system
92
2. iDRAC port
4. SD vFlash media card slot
6. slots on the chassis
8. iDRAC port card holder