Configuring The Touch Screen - Crestron TPMC-9 Operation Manual

Crestron TPMC-9
Operations Guide – DOC. 6965E
• Each device using IP to communicate with a control system must have a
unique IP ID.

Configuring the Touch Screen

The TPMC-9 is configured from the setup menu.
NOTE: The only connection required to configure the touch screen is power. Refer
to "Hardware Hookup" which starts on page 22 for details.
NOTE: The TPMC-9 can take up to 45 seconds to boot to a display after initial
power up.
NOTE: If no project has been loaded or if an invalid project has been loaded, the
touch screen displays an error message and defaults to the setup menu screen.
The setup screens allow basic configuration procedures prior to regular operation of
the touch screen. To enter the setup screens, touch the panel while applying power to
the unit. The setup screens can also be entered by touching the upper left corner,
lower left corner, upper right corner and lower right corner of the panel twice in
sequence (upper left, lower left, upper right, lower right, upper left, lower left, upper
right, lower right). This sequence must be performed within five seconds and touches
must be all the way in the corners.
The main "Setup" menu opens, as shown in the illustration that follows. The
functions provided by each button are detailed in subsequent paragraphs.
TPMC-9 "Setup" Menu
The "Setup" menu provides access to all basic functions and parameters. There are
buttons for Ethernet, IP Table, Video, Audio, Cresnet, Diagnostics and About.
There are also buttons to increase and decrease Screen Brightness and Standby
Timeout as well as a button to enable/disable system messages and a Save & Reboot
button to save settings and reboot the touch screen.
9" Tilt Touch Screen
9" Tilt Touch Screen: TPMC-9 • 11