Brady BBP12 User Manual page 40

Item
Darkness
Print Speed
Tear Off
Print mode
Print Width
List Fonts
List Images
List Formats
List Setup
Control Prefix
Format Prefix
Delimiter Char
Media Power Up
BPP12UserManual
Description
Use this item to setup printingdarkness. The available setting is
from 0 to 30, and the step is 1. You may need to adjust your
density based on selectedmedia.
Use this item to setup print speed. The increase or decreaseis 1
ips. Available setting is from 2 to 6.
This item is used to fine tune media stop location. Available
setting value is from "+" to "-" or "0" to "9".
This item is used to set the print mode. There are 3 modes as
below,
Printer Description
Mode
Next label top of form is aligned to the
Tear Off
print head burn line location.
Peeler Off Enable the label peel off mode.
Cutter Enable the label cutter mode
This item is used to set print width. The available value is from
"0" to "9".
This feature is used to print currentprinter available fonts list to
the label. The fonts stored in the printer's DRAM, Flash or
optional memory card.
This feature is used to print currentprinter available images list to
the label. The images stored in the printer's DRAM, Flash or
optional memory card.
This feature is used to print currentprinter available formats list
to the label. The formats stored in the printer's DRAM, Flash or
optional memory card.
This feature is used to print currentprinter configuration to the
label.
This feature is used to set control prefix character.
This feature is used to set format prefix character.
This feature is used to set delimiter character.
This option is used to set the action of the media when you turn
on the printer.
Selections Description
Printer will advance one label
Feed
Printer will calibration the sensor levels,
Calibration
determine length and feed label
Length Printer determine length and feed label
No Motion Printer will not move media
Default
16
4 (300dpi)
+000
Tear Off
812 dot
N/A
N/A
N/A
N/A
N/A
N/A
N/A
No
Motion
40