Gap/Black Mark Calibration, Self-test and Dump Mode
Whilecalibratingthegap/blackmarksensor,theprinterwillmeasurethelabellength,printtheinter
nalconfiguration(self-
test)onalabelandthenenterthedumpmode.Calibratingthegaporblackmarksensordependson
thesensorsettinginthelastprintjob.
To calibrate the sensor:
1. Turnoffthepowerswitch.
2. HoldtheFeedbuttondown,thenturnthepowerswitchON.
3. ReleasethebuttonwhenLEDturnsamberandblinks(anytimeduringthe5blinks).
TheLEDcolorwillchangeinthefollowingsequence:
•
4. Theprintercalibratesthesensor,measuresthelabellengthandprintsinternalsettingsthen
entersthedumpmode.
Note:SelectgaporblackmarksensorbysendingGAPorBLINEcommandtotheprinterbef
orecalibratingthesensor.
Self-Test
Theprinterwillprinttheprinterconfigurationafteragap/blackmarksensorcalibration.Theself-
testprintoutcanbeusedtocheckifthereisanydotdamageontheheaterelement,printerconfigur
ationsandavailablememoryspace.
Self-test printout
BPP12UserManual
Amber→Red(5blinks)→Amber(5blinks)→Green(5blinks)→
Green/Amber(5blinks)→Red/Amber(5blinks)→SolidGreen
Model name
F/W version
Firmware checksum
Printer S/N
Configuration file
System date
System time
Printed mileage (meter)
Cutting counter
29