1-Port Oc-192C/Stm-64 Pos/Rpr Vsr Optics Spa Interface Specifications - Cisco 7600 series Hardware Installation Manual

1-Port OC-192c/STM-64 POS/RPR VSR Optics SPA Overview
Table 3-19 1-Port OC-192c/STM-64 POS/RPR VSR Optics SPA LEDs (continued)
LED Label
ACTIVE
STATUS

1-Port OC-192c/STM-64 POS/RPR VSR Optics SPA Interface Specifications

The 1-Port OC-192c/STM-64 POS/RPR VSR Optics SPA contains a SONET/SDH framer to process
incoming and outgoing SONET or SDH frames. The framer operates at OC-192/STM-64 line rates (9.95
Gbps). Packet data is transported with a user-configured encapsulation (such as Point-to-Point Protocol
[PPP]) and is mapped into the STS-192c/STM-64 frame.
The 1-Port OC-192c/STM-64 POS/RPR VSR Optics SPA interface is compliant with the following
RFCs:
•
•
•
The 1-Port OC-192c/STM-64 POS/RPR VSR Optics SPA also provides support for SNMP v1 agent
(RFC 1155–1157) and RFC 1213:
•
•
•
•
1-Port OC-192c/STM-64 POS/RPR VSR Optics SPA Fixed Optical Transceiver,
40-pin Connector, and Cables
The 1-Port OC-192c/STM-64 POS/RPR VSR Optics SPA uses fixed optical transceivers, one for receive
(RX) and one for transmit (TX), for SONET and SDH connection to the network. Very Short Reach
(VSR) optics only are supported.
The 1-Port OC-192c/STM-64 POS/RPR VSR Optics SPA uses single mode SC-type connectors:
•
Cisco 7600 Series Router SIP, SSC, and SPA Hardware Installation Guide
3-38
Color State
Green On
Amber On
Blinking
Off Off
Green On
Amber On
Off Off
Green On
Amber On
RFC 1619, PPP over SONET/SDH
RFC 1662, PPP in HDLC-like Framing
RFC 2615, PPP over SONET/SDH.
RFC 1155, Structure and Identification of Management Information for TCP/IP-based Internets
RFC 1156, Management Information Base for Network Management of TCP/IP-Based Internets
RFC 1157, Simple Network Management Protocol (SNMP)
RFC 1213, Management Information Base (MIB) for Network Management of TCP/IP-Based
Internets:MIB II.
Single-mode—9.95 Gbps, OC-192 optical fiber (SONET STS-192c or SDH STM-64c)
Chapter 3 Overview: Cisco 7600 Series Router Shared Port Adapters
Meaning
Port is enabled by software; there is a valid SONET signal
without alarms.
Port is enabled by software; there is at least one alarm (LOS,
LOF, RDI, and so on).
Indicates SRP mode mismatch alarm.
Port is not enabled by software.
Port is enabled by software; loopback is off.
Port is enabled by software; loopback is on.
SPA power off.
SPA is ready and operational.
SPA power is on and good; SPA is being configured.
OL-5052-08