1-Port Oc-192C/Stm-64 Pos/Rpr Vsr Optics Spa Interface Specifications - Cisco ASR 14000 Series Hardware Installation Manual

1-Port OC-192c/STM-64 POS/RPR VSR Optics SPA Overview
Table 3-12 1-Port OC-192c/STM-64 POS/RPR VSR Optics SPA LEDs (continued)
LED Label
ACTIVE
STATUS

1-Port OC-192c/STM-64 POS/RPR VSR Optics SPA Interface Specifications

The 1-Port OC-192c/STM-64 POS/RPR VSR Optics SPA contains a SONET/SDH framer to process
incoming and outgoing SONET or SDH frames. The framer operates at OC-192/STM-64 line rates (9.95
Gbps).
Packet data is transported with a user-configured encapsulation (such as Point-to-Point Protocol [PPP])
and is mapped into the STS-192c/STM-64 frame.
The 1-Port OC-192c/STM-64 POS/RPR VSR Optics SPA interface is compliant with the following
RFCs:
•
•
For information on SNMP MIB support, see "Implementing SNMP on Cisco IOS XR Software" in
Cisco IOS XR System Management Configuration Guide.
1-Port OC-192c/STM-64 POS/RPR VSR Optics SPA Fixed Optical Transceiver,
Connector, and Cables
The 1-Port OC-192c/STM-64 POS/RPR VSR Optics SPA uses fixed optical transceivers, one for receive
(RX) and one for transmit (TX), for SONET and SDH connection to the network. Only Very Short Reach
(VSR) optics are supported.
The 1-Port OC-192c/STM-64 POS/RPR VSR Optics SPA uses multimode MTP-type connectors:
•
Use a multimode optical fiber cable to connect your router to a network.
Cisco ASR 14000 Series Router PLIM, SIP, and SPA Hardware Installation Guide
3-20
Color State
Off Off
Green On
Amber On
Off Off
Green On
Amber On
RFC 1662, PPP in HDLC-like Framing
RFC 2615, PPP over SONET/SDH
Multimode—9.95 Gbps, OC-192 optical fiber (SONET STS-192c or SDH STM-64c)
Use a multimode optical fiber that has a modal-field diameter of 8.7 ±0.5 microns. (Nominal
diameter is approximately 10/125 microns.)
Chapter 3 Overview: Cisco ASR 14000 Series Router Shared Port Adapters
Meaning
Port is not enabled by software.
Port is enabled by software, and loopback is off.
Port is enabled by software, and loopback is on.
SPA power off.
SPA is ready and operational.
SPA power is on and good, and the SPA is being configured.
OL-17456-01