1-Port Oc-192C/Stm-64 Pos/Rpr Spa Interface Specifications - Cisco 7600 series Hardware Installation Manual

1-Port OC-192c/STM-64 POS/RPR SPA Overview
Table 3-16 1-Port OC-192c/STM-64 POS/RPR SPA LEDs (continued)
LED Label
STATUS

1-Port OC-192c/STM-64 POS/RPR SPA Interface Specifications

The 1-Port OC-192c/STM-64 POS/RPR SPA contains a SONET/SDH framer to process incoming and
outgoing SONET or SDH frames. The framer operates at OC-192/STM-64 line rates (9.95 Gbps).
Packet data is transported with a user-configured encapsulation (such as Point-to-Point Protocol [PPP])
and is mapped into the STS-192c/STM-64 frame.
The 1-Port OC-192c/STM-64 POS/RPR SPA interface is compliant with the following RFCs:
•
•
•
The 1-Port OC-192c/STM-64 POS/RPR SPA also provides support for SNMP v1 agent
(RFC 1155–1157) and RFC 1213:
•
•
•
•
1-Port OC-192c/STM-64 POS/RPR SPA Fixed Optical Transceiver, 40-Pin
Connector, and Cables
The 1-Port OC-192c/STM-64 POS/RPR SPA uses fixed optical transceivers, one for receive (RX) and
one for transmit (TX), for SONET and SDH connection to the network. In Cisco IOS Release 12.0(31)S,
only long-reach (LR) optics are supported.
Cisco Systems qualifies the optics that are approved for use with its SPAs. As of Cisco IOS Release
12.0(31)S Cisco IOS XR Software Release 3.2, the XFP-10GLR-OC192SR and the
XFP-10GER-OC192IR are the only optical transceiver modules qualified for use.
The 1-Port OC-192c/STM-64 POS/RPR SPA uses single-mode SC-type connectors:
•
Use a single-mode optical fiber that has a modal-field diameter of 8.7 ±0.5 microns. (Nominal diameter
is approximately 10/125 microns.)
Use a single-mode optical fiber cable to connect your router to a network.
Cisco 7600 Series Router SIP, SSC, and SPA Hardware Installation Guide
3-30
Color State
Green On
Amber On
Off Off
Green On
Amber On
RFC 1619, PPP over SONET/SDH
RFC 1662, PPP in HDLC-like Framing
RFC 2615, PPP over SONET/SDH
RFC 1155, Structure and Identification of Management Information for TCP/IP-Based Internets
RFC 1156, Management Information Base for Network Management of TCP/IP-Based Internets
RFC 1157, Simple Network Management Protocol (SNMP)
RFC 1213, Management Information Base (MIB) for Network Management of TCP/IP-Based
Internets:MIB II
Single-mode—9.95 Gbps, OC-192 optical fiber (SONET STS-192c or SDH STM-64c)
Chapter 3 Overview: Cisco 7600 Series Router Shared Port Adapters
Meaning
Port is enabled by software; loopback is off.
Port is enabled by software; loopback is on.
SPA power off.
SPA is ready and operational.
SPA power is on and good; SPA is being configured.
OL-5052-08