Chevrolet 2009 Uplander Owner's Manual page 382

CAUTION:
{
Inflating something too much can make it explode,
and you or others could be injured. Be sure to
read the inflator instructions, and inflate any object
only to its recommended pressure.
To use your accessory inflator system:
1. Turn the ignition to ACCESSORY or RUN.
2. Attach the appropriate nozzle adapter, if required,
to the end of the hose that has the pressure gage.
3. Attach that end of the hose to the object you wish
to inflate.
4. Remove the protective cap covering the outlet.
5. Attach the other end of the hose to the outlet.
6. Press the accessory inflator switch. The light in the
switch will come on to show the system is working.
If the accessory inflator system does not turn on or
the light does not come on, the fuse may be blown or
installed incorrectly. See Fuses and Circuit Breakers
on page 5-98 or see your dealer/retailer for service.
5-72
Your accessory inflator will automatically shut off after
about 10 minutes. The light in the switch will blink.
After about one minute you can use the system again.
Press the switch and the indicator light will come on.
Notice: If you run the accessory inflator longer
than 30 minutes at a time, you could damage
the inflator. The repairs would not be covered by
your warranty. Run the inflator for short periods of
time only.
After running the accessory inflator for 30 minutes,
wait at least 10 minutes before restarting the accessory
inflator.
To turn off the inflator:
1. Press the switch and detach the hose, first from the
inflated object, then from the outlet.
2. Put the protective cap back on.
3. Place the inflator kit tools in the pouch, and store in
the rear compartment on the passenger's side.
To put the cover back on, line up the tabs at the bottom
of the cover and put it in place. Push down the tab to
secure the cover.