Installing The Battery - HP Photosmart R507 User Manual

Installing the Battery

Your camera uses a rechargeable HP Photosmart R07 lithium
ion battery (L1812A).
NOTE
The battery that was shipped with your camera is
partially charged, but you should fully charge it before
using it the first time. You can charge the battery while it is
in the camera. See
1
If the Battery/Memory card door is already open, skip this
step and go on to step 2.
Hold the camera with the bottom facing
up, as shown, and slide the Battery/
Memory card door latch to open the
Battery/Memory card door.
2
Insert the battery in the larger slot
as shown, and push it in until the
latch catches.
3
Close the Battery/Memory card
door on the bottom of the camera
by pushing the door down until it
snaps closed.
To remove the battery from the camera, first turn the camera
off. Then open the Battery/Memory card door, release the
battery latch, tilt the camera, and the battery will slide out of
its slot.
Downloaded From camera-usermanual.com HP Manuals
14
Charging the Battery
HP Photosmart R507/R607 User's Manual
on page 16.