Basic Features - Panasonic KX-FT901BX Operating Instructions Manual

9.2 Basic features

Code #01: Setting the date and time
SET DATE & TIME
See page 14 for details.
Code #02: Setting your logo
YOUR LOGO
See page 15 for details.
Code #03: Setting your fax number
YOUR FAX NO.
See page 17 for details.
Code #04: Printing a sending report
SENDING REPORT
To print a sending report for fax transmission
results (page 27).
"ERROR" (default): A sending report will be
printed only when fax transmission fails.
"ON": A sending report will be printed after every
transmission.
"OFF": Sending reports will not be printed.
Code #05 (KX-FT901/KX-FT903 only):
Changing the receiving mode in the auto
answer setting
AUTO ANSWER
"FAX ONLY" (default): Facsimile only mode
(page 36)
"TEL/FAX": Telephone/Facsimile mode (page
36)
Code #05 (KX-FT907 only): Changing the
receiving mode in the auto answer setting
AUTO ANSWER
"TAD/FAX" (default): Telephone Answering
Device/Facsimile mode (page 35)
"FAX ONLY": Facsimile only mode (page 36)
"TEL/FAX": Telephone/Facsimile mode (page
36)
Code #06 (KX-FT907 only): Changing the ring
setting in TAD/FAX mode
TAD RING COUNT
To change the number of rings before the unit
answers a call in TAD/FAX mode. You can select
"1", "2" (default), "3", "4", "TOLL SAVER" or
"RINGER OFF". See page 35 for details.
9. Programmable Features
Code #07: Changing the ring setting in FAX
ONLY mode
FAX RING COUNT
To change the number of rings before the unit
answers a call in FAX ONLY mode.
You can select "1", "2" (default), "3" or "4".
Code #09: Changing the TEL/FAX delayed
ring setting
TEL/FAX RING
If you use an extension telephone in TEL/FAX
mode, select the desired number of times the
extension telephone rings before the unit
answers the call. You can select "1", "2" (default),
"3" or "4". See page 36 for details.
Code #10 (KX-FT907 only): Changing the
maximum incoming message recording time
RECORDING TIME
"VOX" (default): Unlimited within the voice
memory capacity (page 60).
"1 MIN": Up to 1 minute.
Code #11 (KX-FT907 only): Setting the
remote operation ID
REMOTE TAD ID
1. Press {MENU}.
2. Press {#}, then {1}{1}.
3. Press {SET}.
4. Enter any 3-digit number except a number
using 0 or 7.
L The default ID is "111".
5. Press {SET}.
6. Press {MENU}.
Code #13: Setting the dialling mode
DIALLING MODE
If you cannot dial, change this setting depending
on your telephone line service.
"TONE" (default): For tone dial service.
"PULSE": For rotary pulse dial service.
47