Table of Contents
Advertisement
9. Programmable Features
9.2 Basic features
Code #01: Setting the date and time
SET DATE & TIME
PRESS SET
See page 19 for details.
Code #02: Setting your logo
YOUR LOGO
PRESS SET
See page 20 for details.
Code #03: Setting your fax number
YOUR FAX NO.
PRESS SET
See page 21 for details.
Code #04: Printing a sending report
SENDING REPORT
=ERROR
[±]
To print a sending report for fax transmission
results (page 34).
"ERROR" (default): A sending report will be
printed only when fax transmission fails.
"ON": A sending report will be printed after every
transmission.
"OFF": The sending reports will not be printed.
Code #06: Changing the ring setting in FAX
ONLY mode
FAX RING COUNT
RINGS=2
[±]
To change the number of rings before the unit
answers a call in FAX ONLY mode.
You can select "1", "2" (default), "3" or "4".
Note:
L Set feature #77 to "FAX ONLY" (page 55)
beforehand.
Code #06: Changing the ring setting in
TAM/FAX mode
TAM RING COUNT
RINGS=2
[±]
To change the number of rings before the unit
answers a call in TAM/FAX mode. You can select
"2" (default), "3", "4", "5", "6", "7" or "AUTO".
See page 41 for details.
Note:
L Set feature #77 to "TAM/FAX" (page 55)
beforehand.
52
Code #10: Changing the maximum recording
time for incoming messages
RECORDING TIME
=NO LIMIT
[±]
"1 MINUTE": Up to 1 minute.
"NO LIMIT" (default): Unlimited within the voice
memory capacity (page 76).
"GREET ONLY": The unit plays the greeting
message but does not record caller messages.
Code #11: Setting the remote operation ID
REMOTE TAM ID
ID=
A 3-digit remote operation ID must be entered
when operating the answering system remotely.
This ID prevents unauthorized parties from
listening to your messages remotely. After you
store your remote operation ID, remote operation
is possible.
1. Press {MENU}.
2. Press {#}, then {1}{1}.
3. To activate the remote operation feature,
enter a 3-digit remote operation ID.
L To deactivate the remote operation
feature, press {*}.
4. Press {SET}.
5. Press {MENU}.
Code #13: Setting the dialing mode
DIALLING MODE
=TONE
[±]
"TONE" (default)
"PULSE"
See page 19 for details.
Code #17: Setting the ringer type for outside
calls
EXT RINGER TYPE
=RINGER 1
[±]
To set the base unit ringer type from one of 6
types for outside calls. You can select "RINGER
1" (default), "RINGER 2", "RINGER 3",
"RINGER 4", "RINGER 5" or "RINGER 6".
Note:
L To set the cordless handset ringer type, see
page 57.
Advertisement
Table of Contents
